Filter
Top Products
XD SERIES (En/E2)
27
Preparation section Basic section Application section Knowledge sections
23
Selection of DOLBY NR (Noise Reduction)
To stop playback
Selection of reverse mode.
To wind tape at high speed
To fast wind in direction \
The Dolby NR system minimizes the hiss noise heard when
playing tape. When playing a tape prerecorded with Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
Let's put out some sound
To fast wind in direction |
÷Press the 7 key to stop fast winding.
Each press switches the modes as follows.
1 “[”... Both sides are played back (recorded), and
then the tape stops (When 2 key is pressed,
only one side is played back (recorded).
2 “”” .. Both sides are played back endlessly.
(The tape stops after recording onto both
sides.)
3 ““” .. Only one side is played back (recorded),
and then the tape stops.
÷Select the Dolby NR mode according to the recording condition of
the tape.
Transport direction
÷Normal (TYPE ), high (TYPE ), or metal (TYPE ) tape selection is
set automatically.
÷Remove tape slack before loading.
÷Close the door securely.
÷Do not take out the cassette tape until the tape transport has
stopped completely.
Transport direction
Each press switches the modes as follows.
1 “DOLBY NR indicator” ON
........ DOLBY NR is used.
2 “DOLBY NR indicator” OFF
........ DOLBY NR is not used.
1¡
Press while in
the stop mode
REV.MODE
R
O p π
7
RE
V
DOLBY NR
Transport direction indicators
The 2 and 3 indicators indicate the current direction in which
the tape advances when playback or recording is started auto-
matically by the easy operation function, etc. This direction is
the direction stored in memory when the tape was last stopped.
(To switch the tape transport direction, press the play key cor-
responding to the desired direction then press the stop (7) key.)
Lights
Lights
Dolby noise reduction manufactured under license from Dolby Labo-
ratories Licensing Corporation.
“DOLBY” and the double-D symbol are trademarks of Dolby Labora-
tories Licensing Corporation.