Filter
Top Products
XD-SERIES (EN/M,T)
Application section
57
4
Select the delay time.
5
Adjust the volume balance.
6
Press the ENTER key.
When adjusting the center speaker and surround
speaker volume levels :
1 “Test L” (Left)
2 “Test C” (Center)
3 “Test R” (Right)
4 “Test S” (Surround)
The display and test tone output speaker are
switched automatically.
To increase
To decrease
÷ Be sure to adjust from your listening position.
÷ The volume level can be adjusted in steps of 1 dB.
÷ The volume levels can be adjusted in the range from –10
dB to +10 dB.
÷ The set center level value will be stored as the common
setting for “Dolby Pro logic” and “Dolby 3 stereo”.
The following items can be selected by turning the
MULTI CONTROL jog dial.
“20ms” ...
When the listening position is located be-
tween the front and surround speakers
“30ms” ... When the listening position is closer to the
surround speakers
“15ms” ... When the listening position is closer to the
front speakers
Delay time
This refers to the difference in timing of the sound output from the surround speakers with respect to that output
from the front speakers. The delay time setting consists of adjusting this difference in time.
Effective sound adjustment
20mSlelect de s
+Scrolled display (Select delay time)
+Scrolled display (Select Channel Level)
TesSaelect Ch t L
C -ch +8
4
2
¢
3
MULTI CONTROL
SELECT
4
2
¢
3
MULTI CONTROL
ENTER
SELECT
1 Press the MULTI CONTROL key while
“Test C” or “Test S” is displayed.
2 Adjust the surround speaker volumes
equal to the volume of the test tone from
the left and right front speakers.
3 After completing the volumes from all
the speakers, press the SELECT key.
To start surround play, select surround playback with
the LISTEN MODE key or SOUND CONTROL jog dial.
E
Display for the center speaker volume adjust-
ment :
Display for the surround speaker volume adjust-
ment :
S -ch +8
÷ After completion of the settings, the set contents will be
displayed by scrolling.
(Center speaker setting = Surround speaker setting =
Delay time setting= “Press 'ENTER' to Save”)
÷ When the center speaker and/or surround speakers are
set to “No” in the “Surround setting” procedure steps
2 and/or 3, the display and test tone output of the
speakers are not provided.