Kenwood XD-6551 Stereo System User Manual


 
XD SERIES (En/E2)
72
Preparation sectionBasic sectionApplication sectionKnowledge sections
÷Place the disc properly, with the label side
facing upward.
÷Place the disc properly.
÷Clean the disc referring to “Disc handling
precautions”.
÷Try another disc.
÷Refer to “Beware of condensation” and
remove the condensation by evaporation.
÷Place a disc in the CD player.
÷Press the play(6) key.
÷Clean the disc referring to “Disc handling
precautions”.
÷Try another disc.
÷Clean the disc referring to “Disc handling
precautions”.
÷Try another disc.
÷Install the unit in a place not subject to
vibrations.
÷Place the disc correctly along the groove on
the tray, press the OPEN/CLOSE key, en-
sure that the DISC indicator is lit, and press
the play (6) key to start playback.
÷The disc is placed upside down.
÷The disc position is displaced.
÷The disc is extremely dirty.
÷The disc is scratched.
÷Dew is condensed on the optics lens.
÷The disc has not been placed.
÷The player is not put to the play mode.
÷The disc is extremely dirty.
÷The disc is scratched.
÷The disc is dirty.
÷The disc is scratched.
÷The player is subject to vibration.
÷You attempt to close the tray while the
loaded 8 cm (CD single) disc is deviated
from the groove on the tray.
÷Connect properly referring to “System con-
nection”.
÷Adjust to an required volume.
÷Switch MUTE OFF.
÷Unplug the headphone plug.
÷Check the connection cords.
÷Turn the power OFF, remove the short-
circuit and turn the power ON again.
÷Plug headphones securely into the jack.
÷Connect properly referring to “System con-
nection”.
÷Adjust the left/right balance.
Sound is not produced.
“PROTECT” is displayed and sound is not
produced.
No sound from headphones.
Sound is not produced from the left or
right speakers.
÷The speaker cords are disconnected.
÷The volume control is set to the minimum
position.
÷The MUTE switch of remote control unit is
switched ON.
÷The headphone plug is inserted into the
jack.
÷Connection cords of the system are discon-
nected.
÷The speaker cords are short-circuited.
÷The headphones are plugged incompletely.
÷The speaker cords are disconnected.
÷The balance is set to the left or right extrem-
ity.
RemedyCauseSymptom
CD player unit
A CD is placed in the player but it cannot
be played.
Sound is not produced.
Sound skips.
The tray cannot be closed but opens when
the OPEN/CLOSE key is pressed to close
an open tray.
5
Ø
5
5
¢
In case of difficulty
1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function, and not
a malfunction.
2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled.
Notes
Notes
Remote control unit
Symptom Cause Remedy
Remote control operation is not possible. ÷Batteries are exhausted.
÷The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷There is no tape or CD set in the component
to be played.
÷An attempt is made to play the cassette
deck which is recording something.
÷Replace with new batteries.
÷Operate the unit inside the remote control-
lable range.
÷Set a tape or CD in the component to be
played.
÷Wait until the recording ends.
(
(
RemedyCauseSymptom
Amplifier/Speaker unit
6
)
¡
¡
6
¡
6
ˇ•„