Kenwood XD-6051 Stereo System User Manual


 
XD SERIES (En/E2)
41
Preparation section Basic section Application section Knowledge sections
To stop playback
To check the programmed tracks
PGM
MEMO
EDIT RDS EON TA NEWS INFO. TP PTY TOTAL SPACE
AUTO
TUNED
DISC ALL
STEREO
kHz
MHz
MUTE
12
PROG.
N.B.
D2*)3*P-): 1
1
2
3
4
5
11
12
13
14
15
6
7
8
9
10
MAX
7
CHECK
To add a track to the program
1Select the disc.
3Establish the selection.
PTY
SEARCH
231
564
897
0 +10
P.MODE
Playback of CD
Remote control unit only
Blinks.
÷Each time the key is pressed, the program No. (P-NO) and the disc No.
are displayed.
÷The previous display resumes in a few seconds.
2Select the track.
DISC SKIP
Go to step 3 within 8 seconds.
÷To select tracks from more than one CD,
repeat steps 1 to 3 for each track.
÷The added track number is added to the end
of the existing program.
To clear tracks from the program
CLEAR
P.MODE
To clear all track.
Press to clear tracks from the end.
÷Each time the key is pressed, the last track in
the program is cleared.
÷The track being played cannot be cleared.
÷The entire program contents also are erased
when the disc tray is opened.
Disc No.
Track No.
Program No.
Auto space function (Remote control unit only)
When the SPACE key is pressed during programming of tracks,
a non-recorded space of a few seconds will be created between
tracks. By recording tracks with these spaces on tape, the search
and repeat play operations of tape using the DPSS function
(which works by searching the non-recorded spaces) can be
performed reliably.
÷Even when the performances of two tracks are continuous (which
occurs with classical or live recording music), the spaces will be
created if they have different track Nos.
÷To cancel the auto space function, press the P.MODE key or the
SPACE key again.
Go to step
2 within 8
seconds.
Remote control
unit only
For the systems including the DP-MH5