Filter
Top Products
REPEATER OPERATION
Note:
Please consult your dealer for programming the repeater.
When power is applied to the unit, the Power indicator
lights:
• Green when using the main DC jack.
• Red when using the Backup terminal.
Rotate the VOLUME control to adjust the volume.
The BUSY indicator lights green while receiving a signal
and the TX indicator lights red while transmitting.
qq
qq
q Speaker
ww
ww
w CH/STATUS Display
Two, 7-segment digits display the channel number
or status.
ee
ee
e VOLUME control
Rotate to adjust the volume.
rr
rr
r DC SOURCE switch
tt
tt
t Power indicator
Lights green when power is applied from the DC
13.6V jack (DC 13.2V jack on E type versions).
Lights red when power is applied from the BACK
UP battery terminal.
yy
yy
y MIC jack
Connect a microphone to this 8-pin modular jack.
uu
uu
u Programmable Function keys
Press these keys to activate their programmable
functions.
ii
ii
i BUSY indicator
Lights green while a signal is being received.
oo
oo
o TX indicator
Lights red while transmitting.
■ Rear Panel
qq
qq
q TX OUT jack
Connect a TX antenna or a duplexer to this recep-
tacle.
ww
ww
w CONTROL I/O jack
Connect an external programming device or re-
peater controller to this DB-25 interface.
ee
ee
e FUSE
Insert 15 A blade fuses into these fuse holders.
rr
rr
r RX IN jack
Connect a RX antenna or a duplexer to this BNC
receptacle.
tt
tt
t DC 13.6V (K type) / DC 13.2V (E type) jack
Connect a 13.6 V (K type) or 13.2 V (E type) DC
power supply to this jack.
yy
yy
y BACKUP battery terminal
uu
uu
u TEST/SPKR jack
Test input/output jack. Connect an external
speaker to this jack.
TRANSCEIVER OPERATION
■ Receive
Adjust the volume to your desired level. You may need
to readjust the volume when you receive a message
from your dispatcher or another member in your fleet.
• The BUSY indicator lights green while a signal is
being received.
■ Transmit
1 Listen to the channel before transmitting, to make
sure it is not being used.
2 Press the microphone PTT switch, then speak in
your normal speaking voice.
• FCC regulations require that you identify the
station you are calling as well as your own
station (your assigned call sign).
• The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.
CONTROLS AND FUNCTIONS
■ Front Panel
qq
qq
q
ww
ww
w
rr
rr
r
tt
tt
t
yy
yy
y
uu
uu
u
ii
ii
i
oo
oo
o
ee
ee
e
qq
qq
q
ww
ww
w
rr
rr
r
tt
tt
t
yy
yy
y
uu
uu
u
ee
ee
e
* The K type model is
shown in this diagram.