Filter
Top Products
9
Screw the antenna into the connector
on the top of the transceiver by
holding the antenna at its base and
turning it clockwise until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/
microphone attachment point. Using the
antenna in these ways may damage the
antenna and degrade your transceiver’s
performance.
INSTALLING THE (OPTIONAL) ANTENNA
INSTALLING THE BELT CLIP
Note: When first installing the belt clip,
you must remove the battery pack from
the rear of the transceiver.
1 Remove the 2 screws from the
rear of the transceiver, then
remove the small, plastic black
covering that was held in place.
2 Insert the belt clip mount into the
space on the rear of the
transceiver.
3 Using the 2 screws, affix the belt
clip in place.
Note: Do not dispose of the plastic black
covering! If you remove the belt clip,
replace the covering into the space on
the rear of the transceiver. Either this
covering or the belt clip must be in place,
otherwise the battery pack may not
remain installed properly.