Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
47
TONE ALERT
Tone Alert provides an audible alarm when signals are
received on the frequency you are monitoring. In
addition, it shows the number of hours and minutes
elapsed after signals were received. If you use Tone
Alert with CTCSS, it alarms only when a received
CTCSS tone matches the tone you selected.
1 Press [A/B] to select band A or B.
• If necessary, press [F], [A/B] to recall the sub-band.
2 Press [F], [ENT] to switch Tone Alert ON (or OFF).
• A bell icon appears when Tone Alert is ON.
• When a signal is received, an alarm sounds and the bell
icon starts blinking.
• Pressing the PTT switch while the bell icon is blinking
switches Tone Alert OFF.
• When 99 hours and 59 minutes pass after a signal is
received, counting stops.
• Each time a new signal is received, the time resets to
00.00.
STA
CON
PACKET
96
BCON
DUP
9
7
5
Note:
◆
While Tone Alert is ON, there is no speaker output when a signal is
received. To hear receive audio, press and hold [MONI].
◆
When Tone Alert is ON, APO does not turn the power OFF.
◆
When Tone Alert is ON, you can use only the following functions:
•
Lamp ON
•
Lamp Latch ON
•
Monitor
•
Band A/B Select
•
Squelch Level Select
BEEP ON/OFF
The transceiver beeps each time you press a key on the
keypad. You can also switch this function OFF. Access
Menu 1–5–3 (BEEP) and select “OFF”. The default is
“ALL”.
In Menu 1–5–3 you can also select “KEY” and
“KEY+NEW DATA”. Those settings are described in
“APRS” sections {pages 63 and 77}.
TH-D7 E 45 Auxiliary Functions 98.12.4, 0:12 PM47