Filter
Top Products
7.
Please read these safety instructions
carefully. They can help prevent
electrical shock, fire, and damage to
the unit.
Safety Symbols
We’ve placed these safety symbols
on the back of electrically-powered
units to alert you to the danger of
electrical shock. Do NOT remove
the cover or back of the unit,
because there are operating
electrical parts inside that can cause
electrical shock. If the unit needs
servicing, take it to qualified service
personnel—do NOT try to open
the unit and service it yourself.
Safety Precautions
For all units
1. Dispose of the packaging materi-
als properly. After you take the unit
out of its shipping bag, dispose of
the bag, keeping it out of the reach
of children and animals. Be aware
that the bag could cause suffocation.
2. Protect your unit from moisture.
Don’t place your unit near water—
for example, a bathtub, kitchen sink,
laundry tub, wet basement, or near
a swimming pool.
3. Keep your unit out of extreme
hot and cold. Your unit may not
work properly if it is used at
extremely low or freezing tempera-
tures. Don’t place your unit near
radiators, heat registers, stoves, or
other heat sources.
4. Don’t put objects or liquids into
the unit! NEVER permit children to
put anything into the unit.
5. NEVER try to open the unit or
take it apart.
6. To clean, use a clean, dry cloth.
To avoid damage, NEVER use
volatile solvents such as alcohol,
paint thinner, gasoline, benzene, etc.
to clean the cabinet. If this is an
electrically-powered unit, unplug it
before cleaning.
7. Do NOT attempt to service this
unit. You should take the unit to
qualified service personnel for repair
when:
• Objects have fallen or liquids
have been spilled into the unit
• The unit has been exposed to
moisture
• The unit doesn’t appear to oper-
ate normally or exhibits a marked
change in performance
• The unit has been dropped or
the case has been damaged
8. To prevent distortion (and in
some cases, discoloration of TV
pictures), keep the unit away from
sources of magnetic fields, such at
TVs, radios, motorized toys, or
magnetized objects. If the unit is
magnetically-shielded (the manual
Safety First
6.
will state this), it is not subject to
these problems.
9. Do NOT place the unit on an
unstable cart, shelf, stand, tripod,
bracket, or table. if you mount the
unit, follow the instructions in the
manual and, if possible, use a
mounting bracket recommended for
the unit. If you place the unit on a
moveable cart, use caution when
moving the cart to avoid overturn-
ing it.
Additional safeguards for elec-
trically-powered units
1. If you see smoke or smell
anything unusual near your unit, turn
off the entire system immediately,
and unplug it from the wall. Then
contact your Kenwood dealer or
nearest service center.
2. Only connect the unit to a
power supply that matches that
described in the technical specifica-
tions in the back of the manual that
came with it. If you are not sure of
the type of power supply in your
home, ask your Kenwood dealer or
your local power company for help.
To avoid the possibility of fire or
electrical shock, do NOT overload
the electrical outlet or any extension
cords.
3. Place the power supply cords in
such a way that they will not be
walked on or pinched by items
placed against them. Never pull or
stretch power cords, and use special
care with the cords at the plugs, in a
power outlet, and at the point they
connect to the unit.
4. Each unit is equipped with a
polarized power plug (with one
blade wider than the other) that
only fits one way into an electrical
outlet, as a safety feature. If you
cannot fit the plug into your electri-
cal outlet, try turning the plug over.
If it still doesn’t fit, you may need to
have an electrician replace your
outlet with a new one that is UL-
approved.
5. Each unit has ventilation open-
ings to keep it from overheating. Do
NOT cover or block these open-
ings. Place the unit at least 6 in from
the wall so that it is properly venti-
lated.
6. Before a lightning storm or when
you leave the unit unattended and
unused for long periods of time,
unplug it from the wall outlet and
any antenna or cable. This can
prevent damage to the unit from
lightning and power-line surges.
Specifications:
Type Subwoofer system with
built-in amplifier
Amplifier
Power handling 50 watts RMS into 4 ohms, from
20 Hz to 200 Hz, with no more
than 0.04% total harmonic distor-
tion
Phase switching Normal, Reverse
Input sensitivity and input impedance
RCA-type jack 50 mV (10 k-ohms)
Push-type terminals 1.0 V (4.7 k-ohms)
Supply voltage AC 110 V ~ 120 V
Rated power consumption 60 watts
Speaker
Enclosure Vented
Speaker units 8 in (200 mm) cone-type
Nominal impedance 4 ohms
Width 13 in (330 mm)
Height 13 in (330 mm)
Depth 13 in (330 mm) with grille
Net weight 25 lbs
Supplied accessories Feet (4)
Since Kenwood follows a policy of continuous advancement in devel-
opment, these specifications may change without notice.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN