Filter
Top Products
68
KRF-V9300D/KRF-V8300D/KRF-V7300D
Troubleshooting
Symptom Cause Remedy
The video is not output or is disturbed. The video component is not connected properly. Connect it properly by referring to <Connections>.
$ – ª
If the video component is connected to this unit through
HDMI connection, the digital video signal input from the
HDMI input terminals is output only at the HDMI monitor
output terminal.
Video signal may not be output depending on the
connecting method and connected components.
Refer to the instruction manuals that come with the
connected components.
The input of the TV monitor is not set properly. Confirm the input setup of the TV monitor.
A non NTSC/PAL video signal is input. Set the video setup of the video player component to
NTSC/PAL. Refer to the instruction manual of the video
player component.
The HDMI video input is set to "Off" in the HDMI setup. Perform the HDMI setup again by referring to <HDMI
input setup –"HDMI Input"–>. ‚
PURE AUDIO MODE is set to "ON". If PURE AUDIO MODE is set to "ON",
the video circuitry is switched off and only the input HDMI
video can be output. Set PURE AUDIO MODE to "OFF".
y
Display is turned off. PURE AUDIO MODE is on. While the PURE AUDIO MODE is on, the display is turned
off. Turn off the PURE AUDIO MODE. y
Tuner
Symptom Cause Remedy
Radio stations cannot be received. No antenna is connected.
Connect an antenna. •
The broadcast band is not set properly.
Set the broadcast band properly. Y
The frequency of the desired station is not tuned.
Tune in the frequency of the desired station. Y
Interference Noise due to ignition of an automobile. Install the outdoor antenna away from the road.
Noise due to interference from an electric appliance. Turn off the power to the appliance.
Noise due to a nearby TV set. Install the unit farther away from the TV.
Remote control unit
Symptom Cause Remedy
Remote control operation is not possible. The remote control is not set to the source operation
mode you wish to control.
Press the appropriate Input Source key to select the source
you wish to control.
The remote control has not been changed to the operation
mode for the Kenwood DVD player you wish to control.
Press the [DVD] key to activate the operation mode for the
component you want to control before operation. Á
Batteries are exhausted.
Replace with new batteries. @
The remote control unit is too far away from the main
system, controlling angle is too large, or there is an
obstacle between this unit and the remote.
Operate the remote control unit within the controllable
range. #
There is an obstacle between this unit and the remote
control unit.
Remove the obstacle.
Operation is attempted while recording mode is set to on. Some funcions cannot control while the recording mode
is set to on. When not recording, set the recording mode
to off. P
Resetting the MicrocomputerResetting the Microcomputer
If the unit is completely inoperable, the display is not normal or a problem cannot be solved even after checking the list in
<Troubleshooting>, it is required to reset the microcomputer in the unit.
While holding down [ ] key on the unit, unplug the power cord and plug it back in.
• Please note that resetting the microcomputer will clear the contents of the memory and return the unit to the state it was in when it left the
factory.
Troubleshooting