Filter
Top Products
4
EN
ENGLISH
Preparing the remote control
Loading the batteries
1 Remove the cover. 2 Insert the batteries.
3 Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity markings.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER
RCVR
key on the remote control. When the power comes
ON, press the key you want to operate.
POWER RCVR
6 m
• When pressing more than one remote control key successively, press
the keys securely by leaving an interval of 1 second or more between
keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2.When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3.Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent
malfunction.
Before applying the power
Unpacking
Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1) AM loop antenna (1)
Remote control unit (1) Batteries (R6/AA) (2)
RC-R0823
If any acccessories are missing, or if the unit is damaged or fails to
operate, notify your dealer immediately. If the unit was shipped to you
directly, notify your shipper immediately. Kenwood recommends that
you retain the original carton and packing materials in case you need to
move or ship the unit in the future.
Keep this manual handy for future reference.
Memory back up function
Please note that the following items will be deleted from the unit's
memory if the power cord is disconnected from the AC outlet for
approximately 1 day.
•Power mode.
•Input selector settings.
•Picture output.
•Speaker ON/OFF.
•Volume level.
•BASS, TREBLE, INPUT level.
• TONE ON/OFF.
• LOUDNESS ON/OFF.
•Dimmer level.
•MD/TAPE settings.
•Listen mode setting.
•Speaker settings.
• SW RE-MIX ON/OFF.
• Distance setting.
•Input mode setting.
•Midnight mode setting.
• PRO LOGIC II mode setting.
• CS II mode setting.
•Broadcast band.
•Frequency setting.
•Preset stations.
•Tuning mode.
•DSP mode.
•ACTIVE EQ mode.
•SPEAKER EQ mode.
Remote sensor
Operating range
(Approx.)
Infrared ray system