Filter
Top Products
13
Preparations
KRF-V7010/V6010/V5010 (En/T)
Preparing for surround sound
Speaker settings
Turn on the receiver.
$
Select a speaker system.
1
2
1 Press the SETUP key to make the subwoofer setting indica-
tion (SUBW) appear.
2 Use the MULTI CONTROL (TUNING/SKIP) to select the appro-
priate subwoofer setting.
1 SUBW YES: A subwoofer is connected to the receiver.
2 SUBW NO: No subwoofer is connected to the receiver.
3 Press the SETUP key to accept the setting.
• The center speaker setting indication (CNTR) appears.
4 Use the MULTI CONTROL (TUNING/SKIP) to select the appro-
priate center speaker setting.
1 CNTR NML (normal): An average size center speaker is
connected to the receiver.
2 CNTR LRG (large): A large center speaker is con-
nected to the receiver.
3 CNTR NO: No center speaker is connected
to the receiver.
5 Press the SETUP key to accept the setting.
• The surround speaker setting indication (SURR) appears.
6 Use the MULTI CONTROL (TUNING/SKIP) to select the appro-
priate surround speaker setting.
1 SURR YES: Surround speakers are connected to the
receiver.
2 SURR NO: No surround speakers are connected to the
receiver.
7 Press the SETUP key to accept the setting.
• The receiver enters the speaker volume level adjustment mode.
• In steps 3 and 4, indications appear only for the selected
channels of the speakers that require adjusting.
To enable you to obtain optimum enjoyment from the receiver’s
listening modes, make sure to complete the speaker settings as
described below.
s
UBW EsY
A
SP
SW
R
L
STEREO
C
NTR EsY
A
SP
SW
R
L
STEREO
Loading the batteries
Preparing the remote control (RC-R0307)
• Insert two AA-size (R6) batteries as indicated by the polarity mark-
ings.
3 Close the cover.
2 Insert the batteries.
1 Remove the cover.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Remote sensor
Model: RC-R0307
Infrared ray system
6 m
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
2
1
2
1
30˚ 30˚
TUNING/SKIP
SETUP
MULTI CONTROL
SETUP
VIDEO
SETUP
MULTI CONTROL
RC-R0507 RC-R0307
Continued to next page
Setting up the system