Filter
Top Products
16
EN
ENGLISH
Preparing for surround sound
6
Adjust the LFE (Low Frequency Effects) level
1 Select the LFE LEVEL from the set up displays and press the
SETUP key again.
2 Use the MULTI CONTROL Knob or MULTI CONTROL %/fi keys
to adjust the LFE LEVEL.
• The LFE LEVEL can be adjusted from 0dB to -10dB in 1dB step
decrements.
3 Press the SETUP key to accept the setting.
4 Setup is complete when the EXIT indication appears.
• The speakers you have selected should appear on the display.
Confirm that all the speakers have been correctly selected.
5 Press the SETUP key to exit the SETUP mode.
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the CLIP indicator
will blink to indicate the source signal. Adjust the input level.
1 Use the INPUT SELECTOR knob to select the source of which the
input level you want to adjust.
• You can store a separate input level for each input source.
2 Press the SOUND key repeatedly until the “INPUT” indication
appears.
3 Use the MULTI CONTROL knob or MULTI CONTROL %/fi keys to
adjust the input level.
• The input level may be adjusted to any one of three settings: 0dB,
-3dB, and -6dB. (The initial setting is 0dB.)
4 Press the SOUND key again to return to the input indication.
04.1.22, 4:14 PM16