Kenwood KRF-V5020 Stereo Receiver User Manual


 
5
KRF-V7020/V6020/V5020 (En/T)
Preparation
*
**** ***
;
FM
AM
kHz
MHz
3 STEREO
DSP
B
S.DIRECT
A
SP TI.VOL
MUTE
RDS
EON PTY
TP TA NEWS
DOWNMIX
MONITOR
PRO LOGIC
TUNED
MEMO.
AUTO
ST.
S
SW
C
RS
R
LS
L
1
2
8
3 6 74 5
9
(^%$#0 & *
SP
SPEAKERS
MUTE
!@
A
SPEAKERS
B
BASS BOOST
VIDEO 2/
MONITOR
SOURCE
DIRECT
LISTEN MODE
SOUND
SETUP
MULTI CONTROL INPUT SELECTOR
VOLUME CONTROL
DOWN
UP
STANDBY
AV SURROUND RECEIVER
ON / STANDBY
PHONES
- ON OFF
POWER
PTY
TA/NEWS DISPLAY
BAND
AUTO
MEMORY
VIDEO 1
VIDEO L—AUDIO—R
FRONT
REAR
Display
Speaker selection indicators
Output channel indicators
Band indicators
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
3 STEREO indicator
STEREO indicator
1 POWER key $
Use to turn the main power ON/OFF.
2 ON/STANDBY (
) key $
Use to switch the power ON/STANDBY
when the POWER is turned ON.
STANDBY indicator
3 PTY key
Use to perform PTY search.
4 TA/NEWS key )
5 DISPLAY key *
Use to change the display indications when
receiving RDS broadcasts.
6 BAND key &
Use to select the broadcast band.
7 AUTO key &
Use to select the auto tuning mode.
8 MEMORY key *
Use to store radio stations in the preset
memory.
9 VOLUME CONTROL knob %
0 PHONES jack ^
Use for headphone listening.
! SPEAKERS A key $
Use to turn speaker system A on and off.
SPEAKERS key (KRF-V5020) $
Use to turn the speakers on and off.
@ SPEAKERS B key $
Use to turn speaker system B on and off.
MUTE key (KRF-V5020) ^
Use to temporarily mute the sound.
About the STANDBY indicator
This unit has a STANDBY indicator. When the STANDBY indicator is lit, the unit consumes a small amount of power to preserve the memory. This is called
STANDBY mode. This mode also lets you turn the power ON using the remote control.
Names and functions of parts
Frequency display,
Input display,
Preset channel display,
Surround mode display
Speaker indicator
MUTE indicator
PRO LOGIC
indicator
S.DIRECT indicator
MONITOR indicator
DSP indicator
TI.VOL indicator
For KRF-V5020
RDS indicator
For KRF-V5020
# BASS BOOST key %
Use to select the maximum adjustment
setting for the low frequency range.
$ VIDEO 2 / MONITOR key 8^
% SOURCE DIRECT key ^
^ LISTEN MODE key £
Use to select the listening mode.
& SOUND key ¢
Use to adjust the sound quality and ambi-
ence effects.
* SETUP key #
Use to select the surround sound settings.
( MULTI CONTROL knob
Used to make a variety of settings.
) INPUT SELECTOR knob %
Use to select the input sources.
¡ VIDEO 1 input jacks
(For KRF-V7020)
FRONT/REAR key
Use to select FRONT or REAR for the VIDEO 1
input.
For KRF-V7020