Kenwood KRF-V8060D Stereo Receiver User Manual


 
31
EN
Ambience effects
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output channels and
the receiver, you can enjoy surround sound playback.
When you try to play a disc other than Dolby Digital such as DTS CD, no
sound is produced or, noise may be heard. To avoid this situation, make
sure that you connect the component to the receivers DVD/6CH INPUT
jacks through a surround processor which can decode the surround
signal you want to listen to.
Connecting a DVD player which can decode the surround signal itself is
also acceptable.
INPUT MODE
DVD/6CH
INPUT MODE
VOLUME
DVD/6CH
VOLUME /
Preparations
Connect your DVD player to the DVD/6CH jacks of the receiver.
Turn on all other components that will be used.
Complete Preparing for surround sound. )
1
Press “DVD/6CH” as the input source.
If speaker system B is on when DVD/6CH is selected as the input
source, it switches off and speaker system A turns on automati-
cally.
2
Select "6CH INPUT" by pressing the INPUT MODE key.
3
Start playback of the DVD software.
4
Adjust the volume.
It is not possible to adjust the volume level or sound quality (SET
UP, SOUND) of the channels separately when the receiver is in the
DVD/6CH mode. Adjust the volume with the controls of the DVD
player.
For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofers own volume control.
3
DSP mode (Digital Signal Processor).
DSP can produce these effects without spoiling the sound quality of
the original music or video source.
1 Pressing the DSP key or DSP MODE key will display the
current DSP MODE status.
2 Each press of the key will switch to the next status as shown
bellow:
1 ARENA : DSP surround ARENA mode.
2 JAZZ CLUB : DSP surround JAZZ CLUB mode.
3 THEATER : DSP surround THEATER mode.
4 STADIUM : DSP surround STADIUM mode.
5 DISCO : DSP surround DISCO mode.
The DSP mode selection is displayed for approximately 3 seconds.
For fine adjustment of the DSP effects, please refer to Adjusting
the sound. ¤
4
Adjust the volume.
Notes
Depending on the type of the signal or speaker setting, some listening
modes cannot be selected.
When playback is started, the sound may be cut or interrupted before
the input source is confirmed as Dolby Digital.
To enjoy Dolby Digital surround (as well as all the other listening modes)
from a single component, be sure to use a Dolby Digital compatible
source component.
•VR6060/29-34/EN 3/11/02, 8:53 PM31