Filter
Top Products
14
EN
1 Strip coating.
2 Push the lever.
3 Insert the cord. 4 Return the lever.
Setting up the system
Connecting the terminals
Speaker impedance
After confirming the speaker impedance indications printed on the
rear panel of this model, connect speakers with matching impedance
ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of this model could result in malfunctions
or damage to the speakers or this model.
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be
unnatural with ambiguous acoustic imaging. Be sure to connect the
speakers correctly.
Connecting the antennas
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from this model, TV set, speaker cords and power cord, and adjust the
direction for best reception.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable
signal reception we recommend using an outdoor antenna. Disconnect
the indoor antenna when you connect one outdoors.
FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna into
the room and connect it to the FM 75Ω terminal.
AM antenna terminal connections
1 Push lever. 2 Insert cord. 3 Release lever.
FM antenna terminal connections
Insert the connector.
Use an antenna
adapter
(Commercially
available)
Attach to the
stand
AM loop antenna
FM indoor antenna
FM outdoor antenna
VR-804
KRF-V4080 and
KRF-V5580D
VR-804
KRF-V4080D
and KRF-V5580D
+
-
+
-
GND
AM
ANTENNA
FM
75Ω
04.1.22, 9:11 PM14