Kenwood KRC-38MR Cassette Player User Manual


 
17
The use of any accessories except for those provided might
result in damage to the unit. Make sure only to use the
accessories shipped with the unit, as shown above.
2CAUTION
Accessories
..........................................1
..........................................1
..........................................2
..........................................1
1
2
3
4
External view Number of items
..........................................4
..........................................4
..........................................1
5
6
7
Installation Procedure
1. To prevent a short circuit, remove the key from the ignition and
disconnect the - battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the following order: ground,
battery, ignition.
5. Connect the wiring harness connector to the unit.
6. Install the unit in your car.
7. Reconnect the - battery.
8. Press the reset button.
If your car's ignition does not have an ACC position, connect
the ignition wires to a power source that can be turned on and
off with the ignition key. If you connect the ignition wire to a
power source with a constant voltage supply, as with battery
wires, the battery may die.
If the console has a lid, make sure to install the unit so that the
faceplate will not hit the lid when closing and opening.
If the fuse blows, first make sure the wires arent touching to
cause a short circuit, then replace the old fuse with one with
the same rating.
Do not let unconnected wires or terminals touch metal on the
car or anything else conducting electricity. To prevent a short
circuit, do not remove the caps on the ends of the unconnected
wires or the terminals.
Connect the speaker wires correctly to the terminals to which
they correspond. The unit may be damaged or fail to work if you
share the - wires or ground them to any metal part in the car.
After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
Insulate unconnected wires with vinyl tape or other similar
material.
Some disc changers need conversion cords for connection. See
the section on "Safety Precautions" for details.
2CAUTION
7:KRC-408/308S only
KRC-408_U.S_K_ms r3 00.12.27 0:09 PM Page 17