Filter
Top Products
— 36 —
English
Basic operations of remote control (See page 8)
Optional
Tape Mode
• T.ADV buttons
Press the 4 button to start play again at the beginning of the
current track.
Press the ¢ button to start play at the beginning of the next
track.
• REW button
Rewinds the tape.
• FF button
Fast forwards the tape.
Do not set the remote control on hot places such as above the
fascia panel (dashboard).
Replacing the Lithium Battery:
Use one lithium battery (CR2025).
Remove the case following the instructions as illustrated.
Insert the battery with the
+ and – poles aligned properly,
following the illustration inside the case.
Store unused lithium batteries out of the reach of children. Contact
a doctor immediately if the battery is accidentally swallowed.
A portion of the operations may not be possible, depending on the
unit that is connected.
NOTE
2WARNING
2CAUTION
2
1
To open
① Keep on slide
➁ Pull out.
All Modes
• VOL. buttons
Keep on pressing the u button to turn the volume up.
keep on pressing the d button to turn the volume down.
• TUNER button
Selects the tuner mode.
• TAPE button
Selects the tape mode.
• CD•MD CH button
Selects the disc control mode.
The disc control mode will differ depending on the unit that is
connected.
NOTE
Tuner Mode
• Number/ letter entry buttons
Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the
frequency of the station.
• TUNE buttons
Press the 4 button to make decreasing seeks (using the
preset tuning mode).
Press the ¢ button to make increasing seeks (using the preset
tuning mode).
• AM/FM button
Press the AM button to select the MW and LW bands.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
• DIRECT/OK button
Selects the direct access tuning mode, used to input
frequencies directly. Press this button again to cancel the mode
whilst it is operating.
During Station name preset play mode, selects station.
• DNPP button
Enters and cancels the Station Name Preset Play mode.