Filter
Top Products
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
TEL MUTE
P.CONT
ANT.CONT
— 25 —
Connecting Cables to Terminals
Rear right output (Red)
Rear left output (White)
Connector Function Guide
Pin Numbers for
ISO Connectors
Cable Colour Functions
External Power
Connector
A–4
A–5
A–7
A–8
Speaker
Connector
B–1
B–2
B–3
B–4
B–5
B–6
B–7
B–8
Yellow
Blue/White
Red
Black
Purple
Purple/Black
Gray
Gray/Black
White
White/Black
Green
Green/Black
Battery
Power Control
Ignition (ACC)
Earth (Ground)
Connection
Rear Right (
+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
KENWOOD disc changer control input
Battery cable (Yellow)
Ignition cable (Red)
FM/AM antenna input
Antenna Cord (ISO)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
To connect the KENWOOD
navigation system, consult
your navigation manual.
NOTE
Wiring harness
(Accessory1)
If no connections are
made, do not let the cable
come out from the tab.
Power control/ Motor
antenna control cable
(Blue/White)
TEL mute cable (Brown)
Connect either to the power
control terminal when using
the optional power amplifier,
or to the antenna control
terminal in the vehicle.
Connect to the terminal that is
grounded when either the
telephone rings or during
conversation.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Fuse (10A)
If no connections are made,
do not cut the tube off from
the edge of the cable.
(KRC-278RA/278RG//23RA/23RG only)
To connect the Disc
changer, consult your
Disc changer manual.
NOTE