Filter
Top Products
13
Preparations
OperationsOther
KR-V9090/8090 (En/T)
Setting up the system
Loading the batteries
•Insert four AAA-size (LR03) batteries as indicated by the polarity markings.
1. The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.
2. Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate or if the
remote control blinks 5 times when you push a key. The remote control is designed to retain set up codes in memory while you change
batteries. Failure to change batteries after receiving the 5 blink battery warning signal may cause all the memory to be lost (KR-V8090 only).
3. Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent malfunction.
3 Close the cover.
2 Insert the batteries.
1 Remove the cover.
Notes
Notes
Operating distance
This remote control has two IR emitters: one to send commands
in a straight line over long distances, allowing you to control the
receiver and your other components from farther away; and one
for wide dispersion of commands in a closer proximity, for near-
field operation even when the remote control is not pointed
directly at the respective component.
30˚ 30˚
10 m
KR-V9090: Model: RC-R0805
KR-V8090: Model: RC-R0606
Infrared ray system
Remote sensor
PRE OUT connections
This receiver has additional preout jacks. These can be used for various purposes, but will need to be connected to an external power
amplifier as shown in the example below. Connecting a speaker cord directly to a PRE OUT jack will not produce any sound from the
speaker.
Be sure to set one of the SPEAKERS keys (either A or B) to the ON position when using the PRE OUT jacks.
Powered
Subwoofer
Center Speaker
Power amp
Power amp
Surround
Speakers
SURROUND CENTER
PRE OUT
SUB
WOOFER
Preparing the remote control
6 m