Filter
Top Products
7
ENGLISH
Getting started
Canceling the display demonstration
(except for
)
The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL
DEMO] \ [PRESS] \ [VOLUME KNOB]
1
Press the volume knob.
[YES] is selected as the initial setup.
2
Press the volume knob again to confirm.
[DEMO
OFF] appears.
If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in
step
2
, [DEMO
MODE] appears and the display demonstration starts.
Setting the demonstration mode
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DEMO MODE], then press to enter.
3
Turn the volume knob to select [ON] or [OFF].
If [ON] is selected, display demonstration starts if no operation is done for about
20 seconds.
4
Hold to finish the procedure.
Main unit
Remote
controller
General operation
SCRL DISP —
Changes the display information.
Scrolls the display information if pressed and held.
Enters clock adjustment mode directly (page 8) if pressed and
held while in clock display screen.
iPod —
For :
Selects “iPod” source.
Enters the controlling mode (MODE ON/ MODE OFF) for iPod
playback if pressed and held. (page 12)
—
For :
Selects Random Play. (page 11)
— AUD Enters [AUDIO CONTROL] / [AUDIO CTRL] settings directly.
— ATT
Attenuates the sound.
• To return to the previous level, press the button again.
Returns to the previous item.
EXIT
Exit from setting mode. (Press and hold
on the main unit will
also exit from the setting mode.)
Continued...
EN02-21_KDC-X396[K]f.indd 7EN02-21_KDC-X396[K]f.indd 7 8/19/11 2:19:13 PM8/19/11 2:19:13 PM