Kenwood KMD-D401 CD Player User Manual


 
— 13 —— 13 —
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before
calling service, first check the following table for possible problems.
SOLUTIONPOSSIBLE CAUSEPROBLEM
Nothing happens when the
buttons are pressed.
The computer chip in the unit is not functioning normally. Press the reset button on the centre unit.
Troubleshooting Guide
A track will not play. Random play has been selected. Turn off random play.
The disc control mode cannot
be selected.
No cable has been connected to the disc changer input
terminal on the unit.
Connect the control cable to the disc changer input terminal
on the centre unit.
The MD cannot be inserted. There is already an MD loaded. Eject the currently loaded MD and then load the new one.
The MD does not load. The insertion orientation of the MD is incorrect or the MD
is upside down.
Insert the MD in the proper orientation.
The MD loads but soon comes
out again.
Nothing is recorded on the MD. Switch the MD for one that is recorded.
The disc cannot be changed. Four MDs have been set in the main unit. Remove the MD currently playing.
No sound can be heard, or the
volume is low.
The fader or balance settings are set all the way to one
side.
Reset the fader or balance settings.
Attenuator is turned on. Turn off Attenuator.
The spectrum analyzer is not
displayed.
The speaker input cable is not connected. Refer to the "Connections" section, and connect the cable.
The fader setting has been adjusted to the rear side. Adjust the fader control on the centre unit to the centre
position.
The analyzer display level has been set too low. Adjust it to a higher level.
The volume is too low. Raise the volume, or alternatively, adjust the analyzer display
level to a higher level.
5 minutes have elapsed since the panel dropped open. When 5 minutes have elapsed since the panel dropped
open, the disc will automatically stop playing.
The system will not enter the
Menu mode.
The system is not in MD play mode. If the main unit is not in MD play mode, it will not go into the
Menu mode.