Filter
Top Products
19
EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
6 “VIDEO2”
7 “DVD/6CH”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOL +/– keys to adjust
the volume.
4
¢
+ +
+
INPUT SELECTOR
VOLUME CONTROL
Input
Selector
VOL
Normal playback
Adjusting the sound
Adjusting the Tone (remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 For the remote control, press and hold the TUNER key for more
than 3 seconds to switch to receiver mode.
2 Press the Tone key to select the TONE mode.
3 Use the MULTI CONTROL knob or Multi %/fi keys to select TONE
ON/OFF.
4 When in TONE ON selection, press the Tone key for the following
displays.
BASS : Select this to adjust the low frequency range.
TREB : Select this to adjust the high frequency range.
5 Use the MULTI CONTROL knob or Multi %/fi keys to adjust the
sound quality.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
Once-touch low frequency emphasis (Bass Boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo modes.
Press the Bass Boost key.
• Press the key once to select the maximum (+10) low frequency
emphasis setting.
• TONE will automatically be turned ON.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode. £~¶
Switching back the previous setting
Press the Bass Boost key again.
4
¢
+
–
+
–
– +
ACTIVE EQ
VOLUME CONTROL
PHONES MULTI CONTROL
SPEAKERS ON/OFF
MUTE
Loudness
Tone
Bass Boost
Active EQ
Mute
VOL +/–
Multi %
/
fi
*5330/16-22/EN 1/21/03, 9:56 PM19