Filter
Top Products
— 28 —
English
Other features (See page 8)
Audio Control Setting
Adjust various parameters of sound quality.
Press the AUD button to enter the control mode.
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
▼
Bass High-pass filter (rear)
▼▲
Treble High-pass filter (front)
▼▲
Balance N-F Level (only when being switched)
▼▲
Fader
Source tone memory
Each source (CD, FM, AM, and disc changer) has its own
memory in which to store the bass and treble tone settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
Press the AUD button to end the control mode.
Setting the high-pass filter
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter works except
during non- fading preout when switching to non-fading.
The factory default settings for front output and rear output are
"through".
NOTE
4
3
NOTE
2
1
Table of Audio Control Setting
Bass
(“BAS”)
Treble
(“TRE”)
Balance
(“BAL”)
Fader
(“FAD”)
Non-Fading
Preout Level
(“NF”)
Bass decreased.
Treble decreased.
Left channel
emphasized.
Rear channel
increased.
The front and rear
sound is emphasized.
Bass increased.
Treble increased.
Front channel
increased.
The non-fading sound is
emphasized.
Right channel
emphasized.
Adjustment
mode
(Display)
4 button ¢ button
Operation of Audio control button
High-pass
filter for front
output
(“HPF F”)
You can select the frequency to be cut, as
follows:
THROU (through) ↔ 40Hz ↔ 60Hz ↔ 80Hz ↔
100Hz ↔ 120Hz ↔ 150Hz ↔ 180Hz ↔ 220Hz
High-pass
filter for rear
output
(“HPF R”)
You can select the frequency to be cut, as
follows:
THROU (through) ↔ 40Hz ↔ 60Hz ↔ 80Hz ↔
100Hz ↔ 120Hz ↔ 150Hz ↔ 180Hz ↔ 220Hz
KDC-PS9060R only
(KDC-PS9060R only)
(KDC-PS9060R only)