Filter
Top Products
Speaker setting allows the System Q settings to be fine-tuned
according to the type of speakers.
Woofer setting allows for Network configuration according to
the type of subwoofers.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Press the Q button to enter the speaker setting mode.
Each time you press the FM/AM button, the mode switches as
follows:
•In speaker setting mode
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off ("SP OFF") / For 6/6x9 in. speaker ("SP 6*9/6inch") /
For 5/4 in. speaker ("SP 5/4inch")/
For the OEM speaker ("SP O.E.M.")
• In woofer setting mode
Press either the 4 or ¢ button to select the type of Sub
woofer. The setting switches as follows.
"WF OFF" / "WF 12inch A" / "WF 10inch A" / "WF 12inch B" /
"WF 10inch B" / "WF 12inch C" / "WF 10inch C" / "WF 8inch"
/ "WF 12inch D" / "WF 10inch D"
Press the Q button to end the speaker setting mode and
woofer setting mode.
• Speaker setting function allows for tuning of bass, middle and
treble.
• Woofer setting allows for tuing of high-pass filter frequency,
low-pass filter frequency and non-fading level.
NOTE
5
4
Speaker setting mode
Woofer setting mode (KDC-__ only)
3
2
1
Speaker & Woofer setting
You can recall the best audio setting preset for different types
of the music.
Switching the Preset Sound Setting:
Each time you press the Q button, the preset sound setting
switches as follows:
As you proceed, each indicator would go on.
The System Q function changes the values of the following
sound quality parameters:
Bass center frequency, bass level, bass quality factor, bass
extend, middle center frequency, middle level, middle quality
factor, treble center frequency, treble level, non-fading level,
high-pass filter frequency for front output, high-pass filter
frequency for rear output, and low-pass filter frequency for non-
fading output.
Their setting values are different depending on the setting of the
speaker setting mode.
NOTE
Flat
Easy
Rock
Jazz
Pops
Top 40
Scan of Flat – Easy
(Default setting)
User memory*
*User memory:
The unit returns to the state
adjusted the last time with
the audio control setting feature.
System Q
While the control panel is sliding, only available buttons are 0,
ATT, ▲, ▼ and SRC.
NOTE
— 11 —
(KDC-X617 only)
KDC-X617_U.S 00.12.26 1:07 PM Page 11