Filter
Top Products
— 33 —
Connecting Wires to Terminals
(KDC-MPV7020/6020/5020)
ANT.
CONT
ILLUMI
P.CONT
FRONT • L
FRONT • R
REAR • L
REAR • R
–
+
FRONT
AUX
REAR
NON
FADING
FM/AM antenna input
15
10 Rear left output (White)/
49 Non-fading left output (White) (KDC-MPV7020/6020 only)
11 Rear right output (Red)/
12 Non-fading right output (Red) (KDC-MPV7020/6020 only)
Fuse (10A) 27
Wiring harness
(Accessory1)22
28
White/Black
31
Gray/Black
34
Green/Black
37
Purple/Black
White
30
Gray
33
Green
36
Purple
39
To front left
speaker 29
To front right
speaker 32
To rear right
speaker 38
To rear left
speaker 35
Ignition wire (Red) 46
Battery wire (Yellow)
47
Ground wire (Black) - (To car chassis) 48
Ignition key
switch 41
Car fuse box
(Main fuse)
42
ACC 44
Car fuse box 45
Battery
43
If no connections are made, do not let the wire come out from the tab. 3
14 Front left output (White)
13 Front right output (Red)
Power control wire (Blue/White)
16
Motor antenna control wire (Blue)
17
Dimmer control wire (Orange / White)
(KDC-MPV7020/6020 only) 19
4 When using the optional power amplifier,
connect to its power control terminal.
7 To car light control switch
5 Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
To KENWOOD disc changer/
DAB control input/KPA-SD100/
KPA-HD100/KPA-SS100 25
To connect these leads,
refer to the relevant
instruction manuals. 26
AUX left input (White) (KDC-MPV7020/6020 only)
AUX right input (Red) (KDC-MPV7020/6020 only)