Kenwood KDC-4060RG CD Player User Manual


 
— 3 —
Safety precautions
To prevent injury and/or fire, take the
following precautions:
Insert the unit all the way until it is fully
locked in place. Otherwise it may fly out of
place during collisions and other jolts.
When extending the ignition, battery or
ground cables, make sure to use automotive-
grade cables or other cables with an area of
0.75mm
2
(AWG18) or more to prevent cable
deterioration and damage to the cable
coating.
To prevent short circuits, never put or leave
any metallic objects (e.g., coins or metal
tools) inside the unit.
If the unit starts to emit smoke or strange
smells, turn off the power immediately and
consult your Kenwood dealer.
Be careful not to drop the unit or subject it to
strong shock.
The unit may break or crack because it
contains glass parts.
Do not touch the liquid crystal fluid if the LCD
is damaged or broken due to shock. The
liquid crystal fluid may be dangerous to your
health or even fatal.
If the liquid crystal fluid from the LCD
contacts your body or clothing, wash it off
with soap immediately.
2WARNING
To prevent damage to the machine,
take the following precautions:
Make sure to ground the unit to a negative
12V DC power supply.
Do not open the top or bottom covers of the
unit.
Do not install the unit in a spot exposed to
direct sunlight or excessive heat or humidity.
Also avoid places with too much dust or the
possibility of water splashing.
Do not set the removed faceplate or the
faceplate case in areas exposed to direct
sunlight, excessive heat or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
Do not subject the faceplate to excessive
shock, as it is a piece of precision equipment.
To prevent deterioration, do not touch the
terminals of the unit or faceplate with your
fingers.
When replacing a fuse, only use a new one
with the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction.
To prevent short circuits when replacing a
fuse, first disconnect the wiring harness.
During installation, do not use any screws
except for the ones provided. The use of
improper screws might result in damage to
the main unit.
2CAUTION