Filter
Top Products
English 9
* Commercially available parts
■ Multi Amplifier with Remote cable connection
(Accessory of KAC-X1D, Optional accessory for XR-1S.)
CAUTION
•
Before connecting the remote controller cables, always turn the Bass boost level knob all the way to the left.
You can control the Bass boost level of the second and subsequent Slave amplifiers simultaneously from the
Master amplifier.
The volume level of each amplifier is determined by the setting of the Master amplifier (INPUT SENSITIVITY, boost
level of the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output of the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same volume as the Master amplifier, adjust the INPUT SENSIVITY to 0.2 V
(max.).
OFF
LINE OUT FILTER
ON
0.2
5
1
0.5
2
4
0.3
3
[
MIN
]
[
MAX
]
OFF
LINE OUT FILTER
ON
0.2
5
1
0.5
2
4
0.3
3
[
MIN
]
[
MAX
]
OFF
LINE OUT FILTER
ON
0.2
5
1
0.5
2
4
0.3
3
[
MIN
]
[
MAX
]
P.CON SPEAKER OUTPUT
REMOTE
FUSE
[
30A
x
2
]
GNDBATT.
LINE IN LINE OUT
L
R
P.CON SPEAKER OUTPUT
REMOTE
FUSE
[
30A
x
2
]
GNDBATT.
LINE IN LINE OUT
L
R
P.CON SPEAKER OUTPUT
REMOTE
FUSE
[
30A
x
2
]
GNDBATT.
LINE IN LINE OUT
L
R
Remote cable
Remote
controller
CENTER UNIT
(CD receiver, etc.)
Master amplifier
Slave amplifier
Slave amplifier
Power control wire*
Extension wire*
RCA cable*
RCA cable*
Use the
attached
Hexagon
Wrench.
Hexagon Wrench
(Small)
XR-1S_KE_1English.indd 9 08.12.18 2:54:21 PM