Filter
Top Products
English 5
40
40
40
Remote cable
Remote controller
CENTER UNIT
(CD receiver, etc.)
You can control the Bass boost level of the
second and subsequent Slave amplifiers
simultaneously from the Master amplifier.
The volume level of each amplifier is determined
by the setting of the Master amplifier (INPUT
SENSITIVITY, boost level of the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output of
the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same
volume as the Master amplifier, adjust the INPUT
SENSIVITY to 0.2 V (max.).
2CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
* Commercially available parts
■ Multi Amplifier with Remote cable connection (Optional accessory)
Master amplifier
Slave amplifier
Slave amplifier
Power control wire
Extension wire*
RCA cable*
RCA cable*