Filter
Top Products
English 5
•A position:
The input for terminal A is output from
amplifiers A and B.
(AB/SUB)
This switch toggles the input signal of
amplifier SUB.
• AB position:
The input for terminals A and B input is
mixed and output from amplifier SUB.
• SUB position:
The input for the SUB terminal is output by
amplifier SUB.
3 B.M.S.(Bass management system)
switch
Bass boost centered on the frequency set
by the B.M.S. FREQUENCY control.
The B.M.S. only applies to the amplifier
SUB.
• +12 position:
Bass boost +12 dB
•OFF position:
Bass boost OFF
•REMOTE position:
Controls the B.M.S. from the Kenwood
center unit. (Refer to page 5)
0 B.M.S. FREQUENCY control
When the B.M.S. switch is set on "+12dB"/
"REMOTE" the emphasized center
frequency is adjusted.
9 V-COLOR (Variable color) button
Select the ON color for the indicator.
Every time the button is pressed, 7 fixed
colors and the variable color change.
The color can’t be set when the indicator is
blinking.
■ Controlling the B.M.S. from the
Kenwood center unit
(B.M.S. : Bass management system)
When the B.M.S. switch is set in the
remote position, the bass boost amount
and frequency offset can be controlled from
the center unit.
• Bass boost
Center unit
Setting
display
"Flat"/"OFF"/"1" Bass boost OFF (Flat)
"+6"/ "1"/"2" Bass boost +6 dB
"+12"/ "2"/"3" Bass boost +12 dB
"+18"/ "3"/"4" Bass boost +18 dB
• Frequency offset
Center unit
Setting
display
"Normal" It is the B.M.S.
FREQUENCY control
adjustment value.
"Low" The central frequency is 20-
30% low.
For the center unit control method and
setting display, refer to the Instruction
Manual for the center unit.
There may be cases when the center unit
can’t set the "Bass boost +18dB" or
"Frequency Offset".
NOTE
!
Hexagon Wrench
Removing the cover
Tighten
Loosen