Filter
Top Products
6 English
Connection
40
89 0! @
^ &$%#
8 Fuse (40 A)
If you can’t find the specified capacity fuse at
your store etc., consult your Kenwood dealer.
9 Battery terminal
0 Ground terminal
! Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect
it with all the systems.
@ Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
# RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
$ LINE IN terminal
% LINE OUT terminal
The signal that’s input from the line input
terminal is output.
^ REMOTE terminal (KAC-8151D
only)
Connects the Remote cable.
Use the Remote cable of the accessory.
& Speaker level input terminals
• The genuine-accessory car stereo shall
have a maximum power output of no
more than 40 W.
• Do not connect the speaker output leads
from a power amplifier (Optional) to the
speaker level input terminals of this unit,
for this may cause malfunction or
damage.
• Do not connect cables and leads to both
RCA cable input jacks and the speaker
level input terminals simultaneously, for
this may cause malfunction or damage.
•Connect the power control lead to a
power supply which can be turned
ON/OFF by the ignition key switch (ACC
line). With this connection, shock noise
may be generated when the power of the
genuine-accessory car stereo is switched
ON/OFF.
NOTE
NOTE
2CAUTION
NOTE
NOTE
■ Terminal names
KAC-8151D/8101D(KE) 1English 02.11.14 10:42 AM Page 6