Filter
Top Products
7
POWER IN
BATT P.CON(REMOTE)
GND
LEFT
BRIDGED
RIGHT
SPEAKER OUTPUT
- +
■
Power and Speakers cable connection
Power control
(REMOTE) lead terminal
Left
speaker
Right
speaker
Connect the ground cable to a metal
part of the car chassis that acts as an
electrical ground passing electricity to
the battery‘s negative - terminal. Do
not turn the power on if the ground
cable is not connected.
NOTE
• If a buzzing noise is heard from the speakers when the engine is running,
connect a line noise filter (optional) to each of the battery cable.
• Do not allow the cord to directly contact the edge of the iron plate by using
Grommets.
Terminal cover
Fire wall
Grommets
Battery
Ground cable (Black)
Battery cable (Yellow)
Round terminal (Large)
Power control cable
Power terminal
Pass battery and ground cables through supplied
terminal cover and connect to respective
terminals. After completing connections, fasten
terminal cover over terminal bracket.
POWER IN
BATT P.CON(REMOTE)
GND
LEFT
BRIDGED
RIGHT
SPEAKER OUTPUT
Round terminal (Medium)
Round terminal (Small)
(Bridged)
Bridged
If you wish to bridge-connect a speaker,
the speaker impedance must be no less
than 4 ohms.
Connecting a speaker with an impedance
lower than 4 ohms may damage the unit.
examples:
2CAUTION
≥4Ω
L
R
≥8Ω ≥8Ω
L
R
Speaker output cable terminal
Connect the speaker output
cables to these terminals.
Lead terminal
(Commercially
available part)
Speaker output
cable
To prevent fire caused by a short in the wiring, connect a
fusible link or breaker nearby the battery’s positive terminal.
2WARNING