Kenwood KAC-7252 Stereo Amplifier User Manual


 
4 English

'.$

Connection
CENTER UNIT
(CD receiver, etc.)
RCA cable ground terminal
RCA cable*
Lead terminal*
Left speaker
Right speaker
Bridged Connections
Speaker (Bridged)
Battery
Ground wire*
Battery wire*
Protective Fuse*
* Commercially available parts
Power control wire
Left input
Right input
2WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery’s positive terminal.
2CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or
connectors are touching the car body. Do
not remove caps from unconnected wires or
connectors to prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
NOTE
• Do not connect cables and leads to both RCA
cable input jacks and the speaker level input
terminals simultaneously, for this may cause
malfunction or damage.
Terminal cover


RCA cable or Speaker level input connection
Power wire and Speaker wire connection
Remote cable connection (KAC-7252 only)
Remote cable
Remote controller
Genuine-accessory car
stereo (No line output
center unit etc.)
ACC
Battery
Car fuse box
• RCA cable Connections
• Speaker level input Connections
Cable Color of the connector
Left
9
White
·
White/Black
Right
9
Gray
·
Gray/Black
Power control wire
2CAUTION
• Before connecting the remote controller
cables, always set the Bass boost level control
to "0dB".