Kenwood DPX-MP2090U CD Player User Manual


 
Audio file source
? Cannot play an Audio file.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning
of the section on <About CDs> (page 6).
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning
of the section on <About CDs> (page 6).
The recording condition is bad.
Record the media again or use another media.
? The Audio file track time isn’t displayed correctly.
---
There are times when it isn’t displayed
correctly according to the Audio file recording
conditions.
USB device source
? The USB device is not detected.
The USB connector is disconnected.
Connect the connector of the USB device
properly.
? The USB device does not play its audio files.
The USB connector is disconnected.
Connect the connector of the USB device
properly.
The messages shown below display your
systems condition.
EJECT: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
NO DISC: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
TOC ERR: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Clean the CD and load it correctly.
READ ERR: • The number of files or folders which are
stored in the connected USB device is
above the limitation.
• The file system of the connected USB
device is broken.
Copy the files and folders for the USB
device again referring to http://www.
kenwood.com/usb/. If the error
message is still displayed, initialize the
USB device or use other USB devices.
E-05: The CD is upside-down.
Load the CD correctly.
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD,
although it has a title.
NO PANEL: The faceplate of the slave unit being
connected to this unit has been removed.
Replace it.
E-77: The unit is malfunctioning for some reason.
Press the reset button on the unit. If the
"E-77" code does not disappear, consult
your nearest service center.
E-99: Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
Check the disc magazine. And then
press the reset button on the unit. If the
"E-99" code does not disappear, consult
your nearest service center.
English
|
39