Kenwood KDC-MP2028 CD Player User Manual


 
The messages shown below display your
systems condition.
EJECT: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
NO DISC: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
TOC ERR: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Clean the CD and load it correctly.
E-05: The CD is upside-down.
Load the CD correctly.
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD,
although it has a title.
E-15: Media was played that doesn’t have data
recorded that the unit can play.
Use media that has data recorded that
the unit can play.
NO PANEL: The faceplate of the slave unit being
connected to this unit has been removed.
Replace it.
E-99: Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
Check the disc magazine. And then
press the reset button on the unit. If the
"E-99" code does not disappear, consult
your nearest service center.
HOLD: The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
playing again.
LOAD: Discs are being exchanged in the Disc
changer.
READING: The unit is reading the data on the disc.
IN (Blink): The CD player section is not operating
properly.
Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
NA FILE: A MP3/WMA is played with a format that
this unit can’t support.
----
COPY PRO: A copy-protected file is played.
----
English
|
31