Filter
Top Products
Installation
Install CB Module
z Mount the CB module using the two supplied 6 x 30mm bolts
on the top and re-using the lower bolt. Tighten all three bolts
rmly but do not over tighten as this may damage the plastic
fairing lower.
z Route the harness from the CB module behind the left engine
guard and into the left side of the fairing. Find the matching
multi-pin connector at the left side of the radio and connect to
the CB module harness. Press the connectors together rmly
to engage the waterproof seals. Secure the cables as needed
with provided cable ties.
NOTE
o If the optional XM Radio K10400-038 will also be installed,
a K10400-042 Splitter Cable (sold separately) will also be
needed to connect both XM and CB to the OE radio.
Install CB Antenna
z Connect the threaded end of the CB antenna cable to the right-
angle tting on the CB module and rmly hand tighten.