Battery Power Operation
1. Open the battery compartment
cover and insert two “AA”
alkaline batteries inside the
battery compartment. Follow
the polarity as indicated in the
battery compartment.
2. Close the battery compartment
cover.
Note: When the unit is to be
operated using batteries, always
unplug the AC adaptor from the AC
power outlet and the DC input socket
from the set. Otherwise the player
will not operate.
3. (a) Do not mix old and new
batteries.
(b) Do not mix alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
4. If the unit is not to be used for an
extended period of time, remove
the batteries. Old or leaking
batteries can cause damage to
the unit and may void the
warranty.
EN-4
Rechargeable Battery Operation
This unit can fully recharge the specified rechargeable battery, in approximately
15 hours. The rechargeable batteries (NOT supplied) should be recharged before
they are used form the first time because they are low in power or if they have not
been used for a long period (over 60 days)
1.Open the battery compartment cover and insert two of the recommended
rechargeable batteries, matching polarity. (1.2V 650mA)
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM OR
NI-MH TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2. Plug in the AC adaptor (DC 4.5V 500mA) and set the Recharge switch to ON
position to start charging. During charging the RED LED charge indicator will
illuminate.
3. After 15 hours. Please unplug the AC adaptor and switch the Recharge switch to
the OFF position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO
CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES
TO DETERIORATE.
Note: You may play DISC'S whilst charging the batteries.
4. If the operating time decreases drastically even when the rechargeable batteries
are properly recharged, purchase a new set of rechargeable batteries.
5. When charging for the first time or after a long time, playing time may be reduced.
In this case, charge and discharge the batteries several times.
EN-5
POWER SOURCES NORMAL BATTERIES / AC ADAPTOR
AC Adaptor Operation
(DC 4.5V 500mA AC adaptor
not supplied )
1. Insert the DC plug, at the
end of the AC adaptor cord
into the DC input socket, at
the back of the unit.
2. Plug the AC adaptor into a
AC power outlet socket.
CHARGING AND USE OF RECHARGEABLE BATTERIES