Filter
Top Products
Connections
12
Setting up the wireless receiver unit
1 Make sure that the CHANNEL
SELECTOR is set to the 1 position.
2 Fully extend the telescopic antenna
upright.
• If necessary, turn the telescopic antenna until you have the
best reception while hearing the sound of the surround
speakers.
NOTE
• When other DVD digital cinema system or wireless device is nearby
this system, interference or noise may result. In such a case, change
the channel on both the center unit and the wireless receiver unit of
this system.
Example: When the channel 4 is selected
CAUTION
• DO NOT cover the front panel of the center unit with any metallic
object, otherwise the radio wave cannot reach the wireless receiver
unit.
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
• When installing the satellite speakers on the wall;
• Be sure to have them installed on the wall by a qualified personnel.
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
• Care must be taken in selecting a location for speaker installation
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
CHANNEL
SELECTOR
Wireless receiver unit
CHANNEL
SELECTOR
WR L S C H : 4
Wireless receiver unit
Center unit (See “WRLS CH” in “Sound and other settings”
(A pg. 36).)
TH-SW9SW8[B]-04Start.fm Page 12 Thursday, April 1, 2004 11:50 AM