JVC UX-P7 Speaker System User Manual


 
– 7 –
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as
shown in the diagram.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM
Make sure the antenna conductors do not touch any other
terminals and connecting cords.
Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
Connecting Speakers
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–), gray (+) to gray (+) and
blue (–) to blue (–).
Remove the vinyl covering the wire by
twisting it as shown in the diagram.
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
AM EXT
FM
COAXIAL
AM LOOP
75
ANTENNA
]
]
1
2
RIGHT
SPEAKER
IMPEDANCE
MIN
6
SPEAKER
IMPEDANCE
MIN
6
LEFT
RIGHT LEFT
MAIN
SPEAKERS
SUBWOOFERS
1
2
3
Continued
Blue
Red
Speaker cords
Speaker cords
Black
Gray
Right Speaker
Left Speaker
Black BlackBlue Blue
Red
Gray Red
Gray
EN01-11.UX-P7[A] 01.5.22, 2:34 PM7