Filter
Top Products
6
To connect the AM loop antenna
• If the AM loop antenna wire or speaker cords are covered
with vinyl, remove the vinyl to expose the tip of the
antenna by twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
To connect the speaker cords
Connect the right speaker to the RIGHT terminals, and the
left speaker to the LEFT terminals.
When connecting the speaker cords, match the polarity of
the speaker terminals:
• For LOW terminals: Red cord to (+) and black cord to (–).
• For HIGH terminals: Grey cord to (+) and blue cord to (–).
Selecting the Video Signal
When connecting a TV, you can use either one of the video
output terminals—COMPONENT or AV OUT.
After connecting the TV, set the video signal type correctly
for your TV.
• Make sure the unit is not yet turned on. If it is already
turned on, turn off then on again so that the selector setting
becomes active.
Changing the Scanning Mode
This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT
jacks, you can enjoy a high quality picture from the built-in
DVD player by selecting “PROGRE.”
• If the VIDEO OUT SELECT switch is not set to “Y/C,”
this function does not work.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT allow the conductor of the speaker
cords to be in touch with the metallic parts of
the System.
1 Hold
2 Insert
3 Release
1 Hold
2 Insert
3 Release
Y/C
Select for sending S-Video signals through the
AV OUT terminal or for sending component
video signals through the COMPONENT jacks.
RGB
Select for sending the composite video signals
or RGB signals through the AV OUT terminal.
PROGRE
Progressive scanning. For a progressive TV.
INTER
Interlaced scanning. For a conventional TV.
Main Unit
ONLY
VIDEO
OUT
SELECT
Y/C
RGB
Remote
ONLY
PROGRESSIVE
0
PROGRE
INTER
(at the same time)
Connection.fm Page 6 Tuesday, February 17, 2004 10:25 PM