Filter
Top Products
7
English
RIGHT LEFT
MAIN
SPEAKERS
SPEAKER
IMPEDANCE
MIN
4
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2 Turn the AM loop antenna until you have
the best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
Connecting Speakers
Right speaker Left speaker
Black
Red
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red ª to
red ª and black · to black ·.
• If the cords are covered with insulation,
remove a short section of insulation at
the end of each cord by twisting and
pulling it off.
3 Release the finger from the clamp.
• DO NOT connect speakers while the power is
on.
• DO NOT connect more than one speaker to each
speaker teminal.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Speaker
cord
Speaker
cord
1
2
AM EXT
FM
COAXIAL
AM LOOP
75
ANTENNA
]
]
1
2
3
EN01-08_UX-P30[UW]f.pm6 03.6.4, 6:49 PM7