Filter
Top Products
– 10 –
English
Listening to FM and AM Broadcasts
TUNER
BAND
TUNER
BAND
SEARCH/TUNING
ST/MONO
REPEAT
PROGRAM
DIRECTION PLAY/PAUSE
PRESET
TUNER
BAND
DIRECTION PLAY/PAUSE
PRESET
Presetting Stations
You can preset 20 FM and 20 AM stations.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1 Tune in the station you want to preset.
• See “Tuning In a Station” on the left.
2 Press PROGRAM.
The PROGRAM indicator and “00”
start blinking on the display.
3 Press PRESET ∞ or 5 (or
PRE DOWN 8/2 or PRE
UP 3/8 on the remote
control) to specify the
desired preset number.
4 To preset more stations, repeat steps 1 to 3
above, allocating a different preset number to
each station.
notes
When a new station is stored
The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces
the previous frequency in memory.)
Tuning In a Preset Station
1 Press TUNER/BAND to
select tuner mode.
2 Press TUNER/BAND to select the band, FM
or AM.
3 Press PRESET ∞ or 5 (or
PRE DOWN 8/2 or PRE
UP 3/8 on the remote
control) to select the desired
preset number.
Tuning In a Station
1 When the unit is turned on,
press TUNER/BAND to
select tuner mode.
The unit tunes in the last station
tuned in (either FM or AM).
2 Press TUNER/BAND to
select the band, FM or AM.
Each time you press the button, the
band selection alternates between
FM and AM.
3 Press and hold 4 or ¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo,
the STEREO indicator lights up.
To stop searching, press 4 or ¢.
notes
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to
receive or noisy, press REPEAT ST/
MONO to switch to the monaural
reception. The STEREO indicator
disappears from the display.
To restore the stereo reception, press REPEAT ST/MONO
again so that the STEREO indicator lights up.
To change FM/AM tuning interval
The unit’s default tuning interval is 100 kHz/step for FM
reception and 10 kHz/step for AM. You can change this
setting to 50 kHz/step for FM and/or 9 kHz/step for AM
when using the unit in an area of different frequency
allocation system.
1 Press TUNER/BAND to select “FM” or “AM”.
2 While holding down STOP/CLEAR 7 on the unit, press
VOLUME + repeatedly to select the desired tuning
interval.
02_01_19_UXM5_UW_En.p65 5/17/02, 5:23 PM10