JVC UX-L30 Speaker System User Manual


 
– 13 –
Playing Back CDs (CD/CD-R/CD-RW)
This unit has been designed to playback the following CDs:
•CD
CD-R
CD-RW
Continued use of irregular shape CDs
(heart-shape, octagonal, etc.) can damage the unit.
General Notes
In general, you will have the best performance by keeping
your CDs and the mechanism clean.
Store CDs in their cases, and keep them in cabinets or on
shelves.
Keep the unit’s disc tray closed when not in use.
When playing a CD-R or CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs
(CD-ReWritable) can be played back only if they are already
“finalized.”
You can play back your original CD-Rs or CD-RWs
recorded in music CD format. However, they may not be
played back depending on their characteristics or recording
conditions.
Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
Some CD-Rs or CD-RWs may not be played back on this
unit because of their disc characteristics, damage or stain
on them, or if the player’s lens is dirty.
CD-RWs may require a longer readout time. This is caused
by the fact that the reflectance of CD-RWs is lower than for
regular CDs.
Playing Back the Entire CD—Normal Play
1
Press 0 CD on the remote control
(or 0 on the unit).
The unit automatically turns on and the disc
tray comes out.
2
Place a disc correctly on the circle of
the disc tray, with its label side up.
When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3
Press CD 3/8.
The disc tray automatically closes and the first
track of the CD starts playing.
The CD automatically stops when the last track of the
CD has finished playing.
To stop playing, press 7.
To remove the disc, press 0 CD on the remote control (or 0
on the unit).
If the CD cannot be read correctly (because it is scratched, for
example) or an unreadable CD-R or CD-RW is inserted
Playback will not start.
If no CD is inserted
“NO DISC” appears on the display.
If the loaded CD has more than 21 tracks and you select 21st
track or above
“– –:– –” appears on the display instead of the playing time.
DO NOT try to open or close the CD tray by hand
as it will be damaged.
Basic CD Operations
While playing a CD, you can do the following operations.
To stop playing for a moment
Press CD 3/8.
While pausing, the elapsed playing time
flashes on the display.
To resume playing, press CD 3/8 again.
To go to another track
Press ¢ or 4 repeatedly.
¢ :
Skips to the beginning of the
next or succeeding tracks.
4 :
Goes back to the beginning of
the current or previous tracks.
Track number Elapsed playing time
CORRECT INCORRECT
Total track number Total playing time
0CD
BASS
CD
3/8
CD
CD
3/8
CD
¢4
UPDOWN
EN13-16_UX-L30[A]f 02.3.4, 9:08 PM13