Filter
Top Products
2
English
Thank you for purchasing a JVC product.
Please read all instructions carefully before operation, to
ensure your complete understanding and to obtain the best
possible performance from the unit.
Precautions
Installation
• Install in a place which is level, dry and neither too hot
nor too cold—between 5°C and 35°C.
• Install the System in a location with adequate ventilation
to prevent internal heat buildup inside the System.
• Leave sufficient distance between the System and the
TV.
• Keep the speakers away from the TV to avoid
interference with TV.
Power sources
• When unplugging the System from the wall outlet,
always pull on the plug, not the AC power cord.
Moisture condensation
Moisture may condense on the lenses inside the System in
the following cases:
• After starting to heat the room.
• In a damp room.
• If the System is brought directly from a cold to a warm
place.
Should this occur, the System may malfunction. In this
case, leave the System turned on for a few hours until the
moisture evaporates, unplug the AC power cord, then plug
it in again.
Others
• Should any metallic object or liquid fall into the System,
unplug the AC power cord and consult your dealer before
operating any further.
• If you are not going to operate the System for an
extended period of time, unplug the AC power cord from
the wall outlet.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
How to Read This Manual
To make this manual as simple and easy-to-understand as
possible, we have adapted the following methods:
• Button and control operations are explained as listed in the
table below. In this manual, the operations using the remote
control is mainly explained; however, you can use the
buttons and controls on the main unit if they have the same
(or similar) name and marks.
•
Some related tips and notes are explained later in the
sections “Learning More about This System” and
“Troubleshooting” but not in the same section
explaining the operations.
If you want to know more about
the functions, or if you have a doubt about the functions, go
to these sections and you will find the answers.
DO NOT install the System in a location
near heat sources, or in a place subject to
direct sunlight, excessive dust or vibration.
DO NOT handle the AC power cord with
wet hands.
For safety, observe the following
carefully:
• Make sure there is good ventilation
around the main unit. Poor ventilation
could overheat and damage the System.
• DO NOT block the ventilation openings
or holes. If they are blocked by a
newspaper or cloth, etc., the heat may
not be able to get out.
DO NOT disassemble the System since
there are no user serviceable parts inside.
Indicates that you press the button
briefly
.
Indicates that you press the button
briefly
and repeatedly
until the option you want
is selected.
Indicates that you press one of the buttons.
Indicates that you
press and hold
the
button for specified seconds.
• The number inside the arrow indicates the
period of press (in this example, 2
seconds).
• If no number is inside the arrow, press
and hold until the entire procedure is
complete or until you get the result you
want.
• Indicates that you turn the control in the
specified direction(s).
Indicates that this operation is only possible
using the remote control.
Indicates that this operation is only possible
using the buttons and controls on the main
unit.
2 sec.
Remote
ONLY
Main Unit
ONLY
Introduction
UX-G210[C].BOOK Page 2 Monday, December 7, 2009 3:00 PM