Filter
Top Products
13
RIGHT
LEFT
SPEAKER IMPEDANCE
6~16Ω
SPEAKERS
AV
COMPU
LINK
VIDEO OUT
SELECT
PAL NTSC
ANTENNA
AC power cord
To a wall
outlet
S-VIDEO
VIDEO OUT
VIDEO
AUX / MD
AUDIO
RIGHT LEFT
PCM/
STREAM
DVD OPTICAL
DIGITAL
OUT
VOLTAGE
SELECTOR
230V
110V
127V
NOW you are ready to plug in the unit and any other
connected equipment.
When you connect the AC power cord into a wall outlet,
the unit automatically starts the display demonstration
(Automatic display demonstration).
• Each time you press and hold COLOR/DEMO (or
COLOR on the remote control) for more than 2 seconds,
the Automatic display demonstration turns on (“DEMO
ON” appears in the main display) and off (“DEMO OFF”
appears in the main display).
To stop and cancel the display demonstration manually,
press COLOR/DEMO (or COLOR on the remote control)
during display demonstration while the unit is in standby
mode.
• Pressing DIMMER (see page 22) or DISPLAY (see page
17) also cancels the display demonstration.
•“0:00” flashes in the main display until you set the
built-in clock. After setting the clock, the clock time will
appear in the main display while the unit is turned off.
To set the built-in clock, see “Setting the Clock” on page
17.
To start the display demonstration manually, press
COLOR/DEMO (or COLOR on the remote control) while
the unit is in standby mode.
• Each time you press the button, the display demonstration
alternates between on and off.
Setting the DVD Player
You need to set the following, using the setting menu
shown on the TV, before starting playback.
• You can select the language used in the setting menu.
• If an Audio CD or MP3 disc is loaded, you cannot show the
setting menu. Before starting the setting, remove the disc.
• For further information about the setting menu, see pages
55 to 59.
Step
1
: Selecting the On-screen language for the
setting menu
Step
2
: Selecting the monitor type according to
your TV
If audio equipment is connected to the DVD OPTICAL
DIGITAL OUT terminal:
Step
3
: Selecting the output signal type
If audio equipment is NOT connected to the DVD
OPTICAL DIGITAL OUT terminal:
Setting is finished.
Go to the next page to start the setting.
If no operation is done for about five minutes while
the setting menu appears on the TV
The screen saver screen (see page 28) automatically appears on the
TV instead of the setting menu to prevent the TV screen from
being damaged.
To show the setting menu again, press CHOICE while holding
down SHIFT.
If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
EN08_17UX_A7DVD[UJ].pm6 03.2.25, 8:51 PM13