Filter
Top Products
Advanced operations
30
When using the on-screen bar:
1 Press ON SCREEN twice.
The on-screen bar appears on the TV screen.
2 Press Cursor 3/2 to highlight .
3 Press ENTER.
4 Press Cursor Y/5 repeatedly to select
“A-B”.
5 Press ENTER at the beginning of the
part you want to repeat (point A).
6 Press ENTER at the end of the part you
want to repeat (point B).
A-B Repeat Playback starts.
7 Press ON SCREEN.
The on-screen bar disappears.
To cancel
Select “OFF” in step 4, then press ENTER.
NOTE
• When playing back a DVD VIDEO, A-B Repeat Playback is possible
only within the same title.
•“A-B” cannot be selected during Program and Random Playback.
You can lock the tray and prohibit the unwanted disc ejection.
On the center unit ONLY:
While the system is turned off
• The system turns on and “LOCKED” appears on the display
window.
• If you try to eject the disc, “LOCKED” appears to indicate that
the tray is locked.
To cancel
Carry out the same operation again.
• The system turns on and “UNLOCKED” appears on the display
window.
NOTE
• This function also takes effect for the sources other than DVD.
• Before you start operation;
There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
2 Press Cursor Y/5 to select the item
you want to set.
• BAL (Balance):
You can adjust the balance between the front left and front
right speakers.
• DEC (Decode):
When you play an external source (AUX DIGITAL is
selected as a source) that was encoded with Dolby Digital or
DTS Digital Surround, the following symptoms may occur;
• No sound comes out at the beginning of playback.
• Noise comes out while searching for or skipping chapters
or tracks.
AUT (Auto)/PCM:Normally select this. The system
automatically detects the incoming signals.
DOLBY D: Select this if the symptoms above occur
when playing a disc (or software) encoded
with Dolby Digital.
DTS: Select this if the symptoms above occur
when playing a disc (or software) encoded
with DTS Digital Surround.
• A. POS (Audio Position):
Set the audio position of subwoofer so that the subwoofer
level can be automatically adjusted properly. (The smaller
the number becomes, the more the level decreases
automatically when listening in stereo.)
3 Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment display automatically disappears a few
seconds later with the current setting.
NOTE
• When “DOLBY D” or “DTS” is selected, if a signal encoded with
another digital format comes in, you cannot listen to the sound. (The
GDIGITAL or C indicator flashes.)
Tray lock
Press and hold
Sound and other settings
BAL : CENTER
BAL : R
--
5
See page 20 for button locations.
TH-S3[C].book Page 30 Monday, April 12, 2004 11:20 AM