Filter
Top Products
– 13 –
English
3
If you wish to load a third disc,
press DISC CHANGE on the unit
or DISC SKIP on the remote
control.
The disc tray rotates by 120˚.
4
Press 0 again.
The carrousel closes.
About the disc indicators
Each disc indicator corresponds to the disc tray of the same number.
• The disc marker lights up for the disc number you have selected.
• The disc indicator rotates while the corresponding CD is being
played.
• The disc indicator goes off when the unit has detected that there is
no CD on the corresponding disc tray.
Playing Back CDs—All Disc and One Disc
You can play all loaded CDs continuously—All Disc play, or
one selected disc—One Disc play.
All Disc play
1
Load CDs.
• If the current playing source is not the CD player, press
CD 6, then 7 before going to the next step.
2
Press REPEAT repeatedly so that the
ALL DISC indicator lights up on the
display.
• Each time you press the button, the indication on the
display changes as follows:
* See page 16.
Playing Back CDs
CORRECT
INCORRECT
Disc number
Disc indicator
DISC
SKIP
Disc marker
DISC CHANGE
This unit has been designed to playback the following CDs:
Audio CD, CD-R, and CD-RW.
When playing a CD-R or CD-RW
User-edited CD-Rs (CD-Recordable) and CD-RWs
(CD-ReWritable) can be played back when they are already
“finalized.”
• You can play back your original CD-Rs or CD-RWs
recorded in music CD format ONLY. (If CD-RWs have
been recorded in different format, erase all the data on
CD-RWs completely before re-recording on the discs.)
DO NOT play back CD-Rs or CD-RWs
recorded the sound files such as MP3.
• Before playing back CD-Rs or CD-RWs, read their
instructions or cautions carefully.
• Some CD-Rs or CD-RWs may not be played back on this
unit because of their disc characteristics, damage or stain
on them, or if the player’s lens is dirty.
Important notices:
• In general, you will have the best performance by keeping
your CDs and the mechanism clean.
- Store CDs in their cases, and keep them in cabinets or on
shelves.
- Keep the unit’s carrousel closed when not in use.
• Continuous use of irregular shaped discs (heart-shape,
octagonal, etc.) can damage the disc rotating mechanism.
• CD-RWs may require a longer readout time since the
reflectance of CD-RWs is lower than for regular CDs.
Loading CDs
1
Press 0.
The unit automatically turns on and the
carrousel comes out.
2
Place one or two discs correctly on the front
recesses of the disc tray, with its label side up.
• When using a CD single (8 cm), place it on the inner
recess of the disc tray.
REPEAT ALL DISC* REPEAT 1 DISC*
REPEAT 1*
1 DISC
ALL DISC
(initial setting)
.
REPEAT
PROG
Track number Elapsed playing time
Track number of the currently playing disc flashes
(Track numbers exceeding 16 are not displayed.)
EN13-17.MX-K50[UW].pm6 02.5.16, 5:50 PM13