Filter
Top Products
13
To preset stations manually—Manual presetting
You need to preset stations separately for the FM and
AM (MW) bands.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step
2
.
On the remote control ONLY:
1
Tune in to the station you want to
preset.
• See “Tuning in to a Station” on page 12.
2
Press SET.
3
Press UP or DOWN
to select a preset number.
4
Press SET again.
The tuned station in step
1
is stored in the preset
number selected in step
3
.
• Storing a new station on a used number erases
the previously stored one.
When you unplug the power cord or if a power
failure occurs
The tuner preset stations will be erased in a few days. If this
happens, preset the stations again.
Tuning in to a Preset Station
On the remote control ONLY:
1
Press TUNER to select the
band.
The unit automatically turns on
and tunes in to the previously
received station—either FM or AM (MW).
• Each time you press the button, the band
alternates between FM and AM (MW).
2
Press UP or DOWN
to select a preset number.
UP
DOWN
1
4
7
10
2
5
8
3
6
9
10
TUNER
UP
DOWN
To tune in to a preset station directly using the
number buttons
On the remote control ONLY:
Pressing the number button(s)
allows you to select the preset
number you want.
Ex.: For preset number 5, press 5.
For preset number 15, press
+10, then 5.
For preset number 20, press
+10, then 10.
For preset number 30, press
+10, +10, then 10.
Receiving FM Stations with RDS
RDS (Radio Data System) allows FM stations to send
an additional signal along with their regular program
signals. For example, the stations send their station
names, as well as information about what type of
program they broadcast, such as sports or music, etc.
When tuned in to an FM station which provides the
RDS service, the RDS indicator lights up on the
display.
With the unit, you can receive the following types of
RDS signals.
PS (Program Service):
Shows commonly known station names.
PTY (Program Type):
Shows types of broadcast programs.
RT (Radio Text):
Shows text messages the station sends.
Enhanced Other Networks:
Provides information about the types of the
programs sent by other RDS stations.
More about RDS
• Some FM stations do not provide RDS signals.
• RDS services vary among FM RDS stations. For details on
RDS services in your area, check with local radio stations.
• RDS may not work correctly if the received station is not
transmitting the signals properly or if the signal strength is
weak.
SET
EN01-15_UX-H30[B]f.pm6 02.12.26, 1:36 PM13