Filter
Top Products
10
English
Tuning in to a Station
1
Press FM/AM to select either “FM”
or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
2
Press and hold ¢ or 4 (or
UP ¢ or DOWN 4 on the
unit) for more than 1 second.
• ¢ (UP ¢): Increases the frequencies.
• 4 (DOWN 4): Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or UP ¢ or
DOWN 4 on the unit).
When you repeatedly press ¢ or 4 (or UP ¢ or
DOWN 4 on the unit)
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or noisy,
press FM MODE so that the MONO indicator lights up on
the display. Reception will improve.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In stereo mode, you can hear
stereo sound when a stereo program is broadcast.
• Changing the station also cancels the MONO mode.
Listening to FM and AM Broadcasts
FM/AM
Continued
Setting the Tuner Interval Spacing
You can select 10 kHz or 9 kHz apart for the AM tuner
interval spacing and 100 kHz or 50 kHz apart for the FM
tuner interval spacing.
• The interval settings of AM and FM change together.
AM 10 kHz, FM 100 kHzÔAM 9 kHz, FM 50 kHz
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step
2
.
On the remote control ONLY:
1
Press STANDBY/ON to turn off
the unit (standby).
2
Press and hold 7 for a few seconds.
The current interval setting appears on the
display.
3
Press 10 or 9 to select the
interval setting for your area.
• 10: Sets the interval to 10 kHz (AM)
and 100 kHz (FM).
• 9: Sets the interval to 9 kHz (AM)
and 50 kHz (FM).
The new interval setting appears on the display for a few
seconds.
When you change the setting
The preset stations are erased. You will need to preset the stations
again. (See page 11.)
STANDBY/ON
AM 10 kHz, FM 100 kHz
AM 9 kHz, FM 50 kHz
1
4
7
10
2
5
8
+10
3
6
9
FM 50 kHz interval FM 100 kHz interval
10-11_UX-H100[U].p65 04.3.24, 0:02 PM10