Filter
Top Products
19
4
Press MEMORY again while the selected
preset number is flashing on the display.
5
Repeat steps
1
to
4
until you store all the
desired channels.
To erase a stored preset channel
Storing a new channel on a used preset number erases the
previously stored one.
To tune in a preset channel
From the remote control:
1
Press XM.
The last received channel is tuned in.
2
Press the numeric buttons (0 – 9, h10) to
select a preset channel number.
• For preset number 5, press 5.
• For preset number 10, press h10, 1, then 0.
• For preset number 15, press h10, 1, then 5.
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
2
again.
1
Turn SOURCE SELECTOR to select “XM.”
The last received channel is tuned in.
2
Press TUNER PRESET.
“P” flashes on the display, and MULTI JOG now works for
selecting preset channels.
3
Turn MULTI JOG to select a preset number.
• To increase the preset numbers, turn MULTI JOG clockwise.
• To decrease the preset numbers, turn MULTI JOG
counterclockwise.
Changing the channel information
While listening to XM Satellite Radio, the currently selected
channel information appears on the display.
You can change the kind of channel information.
From the remote control ONLY:
Press DISPLAY.
Each time you press the button, the channel information changes
as follows:
CHAN (channel name)* = NAME (artist name/feature) =
TITLE (song/program title) = CAT (category name) = Back to
the beginning
* “CHAN” is the initial setting.
EX.: When the category name is selected:
NOTES
• If you turn off the power or select another source, the display is
changed back to the initial setting.
• When you tune in to another channel, the channel name
appears on the display and then the channel information you
have selected appears.
• When all the text information cannot be shown on the display at
the same time, the text scrolls.
• Some characters cannot be displayed correctly.
LINEAR PCM
L
S.WFR
R
DIGITAL AUTO
LINEAR PCM
L
S.WFR
R
DIGITAL AUTO
After one second
Message
NO SIGNAL
CHECK ANTENNA
LOADING
OFF AIR
UPDATING
• Channel number and “-----”
• Preset number, channel number,
and “-----”
• Channel number and “CH---”
• Preset number and “--->CH---”
Messages on the display
When problems occur, a message appears on the display. In this case, refer to the following solution.
Possible cause
Signals are too weak.
The XM Connect and Play Digital
Antenna is not connected properly.
This receiver is loading the channel
information and audio data.
Selected channel is not currently
broadcasting any signal.
The latest encryption code is being
updated.
No text information for the selected
channel is available.
Selected channel does not exist or
is not subscribed yet.
Solution
Move the XM Connect and Play Digital Antenna
near a south-facing window or where “Channel 1”
can be heard clearly.
Check the connection (see page 5).
It takes a few minutes to complete. Wait until
loading is finished.
Select another channel.
Wait until updating is finished.