Filter
Top Products
20
7 Panorama control for Pro Logic II Music—
PANORAMA CTRL
You can turn on or off the Panorama control for Pro Logic II
Music only when “PL II MUSIC” is activated.
Select “PANORAMA ON” to enjoy “wraparound” sound effect
with side-wall image (“OFF” is the initial setting).
• For Pro Logic II Music, see page 24.
Sound Adjustments Using Remote
Control
You can also use the remote control to adjust the speaker
output levels and the subwoofer output level.
• You can use the test tone to make your favourite adjustments
(except for subwoofer level adjustment).
Adjusting Speaker Output Levels Using Test
Tone
The center and surround speakers are temporarily activated
and you can adjust them when you are listening to stereo
sound or one of the DAP modes is activated.
Notes:
• You cannot adjust the center speaker output level when the center
speaker size is set to “NONE” (see page 15).
• You cannot adjust the surround speaker output levels when the
surround speaker size is set to “NONE” (see page 15).
LEVEL
SURR RSURR L
SUBWFRCENTER
FRONT RFRONT L
7/P
10
2
5
8
0
3
6
9
10
DISPLAY MODE
A/V CONTROL
RECEIVER
TEST
4
1
100
Sound Adjustments
7 Tone—BASS, TREBLE
Adjust the bass and treble sounds as you like (–10 to +10 in 2
step intervals).
•“0” is the initial setting.
7 Subwoofer output level—SUBWFR LEVEL
Adjust the subwoofer output level (–10 to +10 in 1 step
interval).
•“0” is the initial setting.
Note:
Subwoofer output level cannot be adjusted in the following cases:
• When “SUBWOOFER NO” is selected for the subwoofer setting (see
page 15).
• When the HEADPHONE mode is in use (see page 13).
7 Speakers’ output level
Adjust the speakers’ output level so that you can hear sounds
from each speaker at an equal level (–10 to +10 in 1 step
interval).
•“0” is the initial setting for all speakers.
FRONT L LEVEL Left front speaker output level
FRONT R LEVEL Right front speaker output level
CENTER LEVEL* Center speaker output level
SURR L LEVEL* Left surround speaker output level
SURR R LEVEL* Right surround speaker output level
*
You can adjust these items depending on the current speaker
settings (see page 15) and Surround/DSP mode (see “Adjustable
items and selected Surround/DSP mode” on page 27).
Notes:
• You cannot adjust the center speaker output level when the center
speaker size is set to “NONE” (see page 15).
• You cannot adjust the surround speaker output levels when the
surround speaker size is set to “NONE” (see page 15).
7 Effect level for DAP modes—EFFECT
You can adjust the effect level for DAP modes only when one
of the DAP modes is activated (EFFECT 1 to EFFECT 5).
“EFFECT 3” is the initial setting. As the number increases, the
effect becomes more stronger.
• For DAP modes, see page 25.
TEST
CENTER
FRONT L
SURR L
SOUND
FRONT R
SURR R
SUBWFR
LEVEL +/–
18-23_RX-60_5030[J]f 02.11.28, 13:4720